Remote Control Keys - Projector SVGA User Manual

USER GUIDE
The trackball is by default controlling the computer mouse (if the mouse
cable is connected properly). With some functions, like POINTER, MASK
and in the menu system, the mouse control is disabled.
In the menu system, the trackball is used for navigation between the
different alternatives, and when a function is selected, the trackball is used
for adjustment of that function.
Turn on the remote control by sliding the ON/OFF-switch to ON position. To
avoid draining the batteries, turn the remote control OFF after use.
8.1.1

REMOTE CONTROL KEYS

The following table describes each key in detail. Some functions are
memorized, while other functions are only momentary.
The MEM column indicates whether the function setting is memorized.
Switches the remote control on/off (battery save)
ON/OFF
Adjusts contrast.
CONTR
Controls brightness.
BRIGHT
Adjusts audio sound volume.
VOLUME
Turns the projector into either operating or
POWER
standby mode. In standby mode the projection
lamp is switched off.
Automatically adjusts the image correctly
RESET
Applies a mask to the image, which can be moved
MASK
up and down using the trackball.
This key may be programmed to any one of the
PROG
menu controls.
Switches the sound on/off.
MUTE
Holds the image projected on the screen.
FREEZE
SVGA LCD PROJECTOR
18
MEM
MEM
MEM
MEM