Setting The Date/Time - MABIS 04-233-001 Manual Book

Instruction manual E&S 7/20/04

Setting the Date/Time

1. Press the PWR button and hold it down only until '0' flashes on
the display, Fig. 1. Release the button and two '0's will appear.
2. When two '0's appear on the display, Fig. 2, press the MEM
button until the year begins to flash in the lower right corner,
Fig. 3.
3. Use the PWR button to adjust the flashing number. When the
correct year is displayed, press the MEM button to confirm the
year.
4. Once the year is set, the number in the upper left corner of the
display will begin to flash, Fig. 4. Press the PWR button to adjust
the month. Once the correct month is displayed, press the MEM
button to confirm the month.
Fig. 1 Fig. 2
3:31 PM Page 11
Fig. 4
Fig. 3
9
Setting the Date/Time (continued)
5. Once the month is set, the number in the upper right corner of
the display will begin to flash, Fig. 5. Press the PWR button to
adjust the date. Once the correct date is displayed, press the
MEM button to confirm the date.
6. Once the date is set, the number in the upper left corner of the
display will begin to flash, Fig. 6. Press the PWR button to
adjust the hour.
NOTE: hours are displayed in military time (11:00 p.m. = 23:00).
Press the PWR button to adjust the hour. Once the correct hour
is displayed, press the MEM button to confirm the hour.
7. Once the hour is set, the number in the upper right corner of the
display will begin to flash, Fig. 7. Press the PWR button to
adjust the minutes. Once the correct minutes are displayed,
press the MEM button to confirm the minutes.
8. After confirming the time, the display should display the correct
time, Fig. 8. NOTE: if you made a mistake while setting the
clock, remove the batteries and reinsert them. Follow the
"Setting the Date/Time" instructions, starting with setting the year.
Fig. 5 Fig. 6
Fig. 8
Fig. 7
10