Monogram 30" Built-InBottom-Freezer, 2-DrawerRefrigerator Design And Installation Manual page 17

STEP 9 REVERSE DOOR SWING
Skip this step if door swing is satisfactory.
1. Open the fresh food door.
WARNING:
IMPORTANT FOR SAFE HANDLING OF AN
UNLOADED HINGE. DO NOT SKIP STEP 2.
2. Release the hinge springs by using a Torx T-20 wrench
to loosen the Torx screw from
Close the door.
3. Using a 5/32" Allen wrench, remove the 2 screws per
hinge that secure the door to the refrigerator. Have
someone hold the door while removing these screws
to keep the door from falling.
Screws
4. Open the hinges. Using a 5/32" Allen wrench, remove
the 2 screws per hinge that secure the hinge to the
refrigerator cabinet.
Screws
5. Remove the trim and hinge pocket from the top
of the refrigerator and install on the opposite sides.
6. Remove the trim and hinge pocket from the bottom
of the fresh food compartment. Remove the control panel
and gently place in the FZ drawer.
Control Panel
7. Reinstall the control panel.
Installation Instructions
(If needed)
THIS NEXT STEP IS
to 0 on both hinges.
|
STEP 9 REVERSE DOOR SWING
8. The hinges will be reinstalled in opposite corners.
The hinge from the top will be turned over
and installed at the bottom of the fresh food
compartment. The hinge from the bottom will be
turned over and installed at the top of the fresh food
compartment.
Top Hinge
9. Install the screws on the fresh food compartment
cabinet in all 4 places. Screw them in about halfway.
Screws
10. To install the top hinge, turn the hinge in the proper
direction—the section of the bracket that will be
attached to the door should be at the bottom of the
hinge. Slide the hinge over the screws and seat the
tabs into the hinge pocket. Tighten the screws.
Screws
11. To install the bottom hinge, turn the hinge in the
proper direction—the section of the bracket that will
attach to the door should be at the top of the hinge.
Slide the hinge over the screws and seat the tabs
into the hinge pocket. Tighten the screws. Close
the hinge.
12. Remove the hinge brackets from the door and reinstall
them on the opposite end, top and bottom.
17
.
(cont)
Bottom Hinge
Slots for
Tabs