Subwoofer Output; Care And Maintenance - Jensen banshee JiSS-330 Owner's Manual

SUBWOOFER OUTPUT

This unit provides a seperate subwoofer output jack for connecting an external active
(self-powered) subwoofer speaker (not included). This will enhance and expand your sound by
adding an extra deep rich bass channel to the unit. The Subwoofer Output Jack is located on the
back of the unit.

CARE AND MAINTENANCE

- Do not subject the unit to excessive force, shock, dust or extreme temperature.
- Do not tamper the internal components of the unit.
- Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
- Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
- Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps
or motors.
12
TROUBLESHOOTING GUIDE
Symptom Possible Problem
AC Adaptor is not plugged into a
wall outlet or the output connector
The unit does is not plugged into the DC15V IN
not respond (no power) jack on the back of the unit.
Wall outlet is not functioning.
Using no/wrong iPod Adaptor.
iPod does not
iPod does not install properly.
dock properly
iPod is not installed properly.
iPod does not respond
to the speaker system
Your iPod is locked up.
iPod mode is not selected.
iPod is not installed properly.
iPod does not
charge up
iPod is locked up/ frozen.
iPod battery has problem.
Volume level is set too high.
Sound is distorted
Sound source is distorted.
Unit gets warm after This is normal.
extended play at
high volume
13
Solution
Plug the AC adaptor into a wall
outlet and plug the output connector
into the DC15V IN jack on the unit.
Plug another device into the same
outlet to confirm the outlet is working.
Make sure the dock insert is the
proper fit for your iPod.
Remove your iPod from the dock
and check for obstruction on the
connectors in the dock and on your
iPod. Then reseat it in the dock.
Remove your iPod from the dock
and check for obstruction on the
connectors in the dock and on your
iPod. Then reseat it on the dock.
Please make sure that your iPod is
working properly before docking into
the unit. Please refer to your iPod
manual for info on resetting the iPod.
Slide the Audio Input Selection
switch at the back of the unit to
iPod position.
Remove your iPod from the dock
and check for obstruction on the
connectors in the dock and on your
iPod. Then reseat it in the dock.
Please make sure your iPod is
working properly before docking into
the unit. Please refer to your iPod
manual for details on resetting.
Decrease the volume.
If the iPod original sound source is of
poor quality, distortion and noise are
easily noticed with high-power
speakers. Try a different audio source
such as a music CD.
If you are using an external sound
source like older generation of iPod,
try reducing the output volume on the
device itself. Also try turning bass
boost OFF or change the EQ setting.
Turn the unit off for a period of time or
lower volume.