Table of Contents
Advertisement
PLAYING A CD
You can navigate a CD using the buttons on the remote
control or the front panel.
Selecting CD operation:
FUNCTION slide switch to select 'CD' .
•
Move the
Loading a CD:
•
Open the CD compartment by pressing down on the
DOOR CATCH area at the front corner of the CD lid.
•
Holding the disc by the edges, place the disc on the
turntable in the centre of the CD loading bay with the
label uppermost, pressing the centre of the disc to click
it into place.
•
Gently close the CD door.
The unit will read the disc and display the total number of
tracks on the disc.
Removing a CD:
•
Make sure that the disc is stopped.
•
Open the CD compartment by pressing down on the
DOOR CATCH area marked at the front corner of the CD
lid.
•
Gently lift the disc from the front left corner.
The disc will click off the turntable.
•
Holding the disc by the edges, lift the disc off the
turntable and place it back in the case.
•
Gently close the CD door.
Playing a CD:
•
Press the
//, button.
The play symbol will appear on the display and the track
number playing will be shown.
Pausing a CD:
•
Press the
//, button while the CD is playing.
The display will flash.
Stopping CD play:
. button (or the STOP button on the remote
•
Press the
control) while the CD is playing.
CD
The CD will stop.
Selecting tracks:
•
Press the
} or { button to select the next or previous
track.
NOTE:- When pressing { while playing a track, the first press
will replay the current track.
Fast search:
•
Press and
hold the } or { button to fast search forward
or backward through a track.
The track will search at high speed.
CD
Repeat play:
•
Press the
REPEAT button to cycle through the available
repeat modes - 'Repeat 1' , 'Repeat all' or 'Repeat off' .
If a repeat mode is set, the mode selected will be shown on the
display.
Selecting 'Repeat 1' will continuously repeat the current track.
Selecting 'Repeat all' will repeat the entire disc continuously.
You can load a disc and store a programmed selection of up to
20 tracks to play from the disc in your preferred sequence.
To set a program:
•
•
The display will show 01 briefly (the position of this track in the
program), then flash 00.
•
•
The display will show 02 briefly, then flash 00.
•
Playing the program:
•
The program will begin to play and PROG will show on the
display to show that a program is being played.
Selecting tracks:
•
Clearing a program:
•
9
PROGRAM PLAY
Load a disc and wait for it to read.
PROGRAM button.
Press the
Select the track number you want to program by pressing
the } or { button.
To save this track into the program sequence, press the
PROGRAM button.
Repeat these two steps until you have stored all the
tracks in the program sequence.
Press the
/, button to start the program playing.
You can navigate through the tracks stored in the
program by pressing the } or { button.
The program is cleared by opening the CD door or
changing to another function.
Advertisement
Table of Contents
