This warranty is extended to the first consumer only, and proof of purchase is necessary to honor the warranty. If there is no proof of purchase provided with a warranty claim, Marshall Electronics reserves the right not to honor the warranty set forth above.
Page 3
Specifications Intentionally Left Blank AR-DM2X-X Audio Monitor ■ METERS Peak Acoustic Output: 104dB SPL Headphone Power Output: 150 mW AR-DM2-1 Meter Type: 16 x 1 LED Signal Presence Indicators ■ ELECTRICAL Meter Dynamics: Not Available AR-DM21-B AR-DM2-1, AR-DM21-B Meter Type: 16 x 10 Segment LED Bar Graph...
Page 4
Do not force the module into place if it does not move easily. 7. To remove the module, push aside the metal brackets on each side of the slot so that the module is release upward. 8. Close the AR-DM2X-X Audio Monitor by re-fastening the 14 screws on the top panel.
Unpacking ................................ 7 IMPORTANT: The following procedure involves exposing and handling bare electronic components. Proper anti-static precaution must be taken before opening the AR-DM2X-X Audio Monitor to avoid damage during installation. This Input / Output Module Installation......................7 includes working on a static-free surface and wearing a grounded wrist-strap or another type of grounding device.
100% digital processing providing pristine audio quality. Interchangeable input and output modules provide unrivaled is powered on. flexibility – up to four I/O modules can be installed in a single AR-DM2X-X audio monitor, each module with up to 16 channel inputs, providing a possible 64 channels per audio monitor. Input choices include balanced/unbalanced 2.
• AC Power Cable or XLR Power Supply • Operating Instructions * AR-DM2X-X series monitors may be pre-configured with input/output modules or DOLBY module if ordered as such. DOLBY module installation is indicated by a label on the exterior of the unit.
Optional Modules Input Modules Install an Input Module Ensure at least one input module is installed in the AR-DM2X-X audio monitor. If no modules are installed, see Module Installation for detailed instructions. Connect an Audio Source Connect an audio source to the audio monitor. Depending on the chosen input module, the signal could be SDI video with embedded audio, AES/EBU digital audio, analog audio, etc.
The stereo loudspeakers are active unless headphones are connected. Channel-Assign and DOLBY Indicator LEDs ■ Logging LKFS Data (all AR-DM2X-X monitors) over USB The channel assign LED below each bar graph Power Indication LED indicates how that channel is being reproduced...
2/2 L+R/L+R USB Port 1/3 Stereo Ch. The USB port is used to upgrade firmware to the AR-DM2X-X audio monitor. Additionally, the USB port can be used to 1/3 L+R/L+R configure LKFS settings with USB memory stick. 2/3 Stereo Ch.
Illumination of the blue DOLBY LED underneath a channel pair indicates that a DOLBY encoded signal has been Basic operation of the AR-DM2X-X Audio Monitor involves selecting an input module as the audio source, using the LED detected on that channel pair.
Note: If a channel pair contains a DOLBY encoded signal, the corresponding LED bar graphs will not show a signal level. DOLBY signal presence is indicated by the illumination of the blue LED below each channel pair. See the DOLBY Encoded Signals section on page 13 for more information.