Baumatic BFD65W Instruction Manual page 23

BAUMATIC BFD65W dishwasher user manual
d) NEXT, CONNECT THE WATER INLET
(SEE FIGURE BELOW):
Connect the cold water supply hose to a
threaded ¾ inch connector and make sure that
it is fastened tightly in place.
Attach tube C to the cold water supply A.
If the water pipes are new or have not been
used for a long time, let the water run to make
sure that the water is clear and free of
impurities. The water inlet may get blocked and
damage the appliance.
Make sure the water pressure is the same as the
range indicated on the data tag.
DO NOT CONNECT TO THE HOT
WATER SYSTEM!
If your appliance is fitted with an aqua stop
system then this must be fitted vertically
(pointing upwards) not downwards or sideways.
e) THEN, CONNECT THE DRAIN HOSE
(SEE FIGURE BELOW):
The curved end of the drainage hose should be hooked into the drainage stand pipe or, alternatively, over
the edge of your sink.
During installation, make sure that:
• The drainage hose is not kinked or crushed.
• The hose end, relative to the top surface of the dishwasher (SEE FIGURE BELOW), must be
placed at a height between 32cm and 80cm.
• The end of the hose must never be immersed in water.
• The drainage hose must not be extended to more than a maximum length of 1 metre. The
extension must have the same internal diameter. Furthermore, the maximum height at which
the hose end can be placed (in the case of an extended tube) must be reduced from 80cm to
50cm.
• The drainage stand pipe must have an internal diameter of no less than 4 cm.
N :
OTE DO NOT EXTEND THE DRAIN HOSE AS THIS CAN AFFECT THE
PERFORMANCE OF THE DISHWASHER
.
22
22