Disconnect Battery; Remove Old Radio - Jensen CR560X Installation Manual

®

Disconnect Battery

Before you begin, always
disconnect the battery
negative terminal.

Remove Old Radio

Your original car radio is installed in one of four ways, depending on the car.
Bracket Mounted
1. Remove dashboard faceplate
2. Unscrew brackets
3. Disconnect wiring harness and
remove radio
Replacing an Aftermarket Radio
Use a screwdriver to bend tabs completely out
of the way. Pull sleeve from dashboard. The
sleeve should fit tightly and may be damaged
unless you remove it carefully.
Bend
1
Tabs
Flat
4
5588 CR560X_EIN.p65
2 Pull Sleeve Out
Caution: Edges are
sharp. Use a rag
or wear a glove.
4
Removal Tool
Some cars use a special removal tool
to release the radio.
1. Insert the tool(s)
2. Pull out the radio
3. Disconnect wiring harness and remove radio
ISO-DIN
1. Remove trim to expose DIN chassis.
2. Remove the ISO-DIN frame from the
dashboard.
3. Unscrew screws from the sides.
4. Disconnect wiring harness and remove
radio.
1
COMPA EJEC T
CT
DIGITAL RG CD4
AUDIO
00
8 X OVER
SAM PLIN
G . . . 4 X 15
WAT TS
PWR
BAS S BAN VOL
MO/ D
ST
DISP CD SEL
LO/D
X
INT VOL
RPT
RDM
2/29/00, 10:46 PM
CR560X
2
3