RIDGID JP0600 Owner's Manual page 21

CAUTION: Before turning switch "ON", make sure
the blade guard is correctly installed and operating
properly.
12. On-Off Switch
Turns the tool on and off. The "yellow button" is a key.
When it is inserted in the switch lever, the power may
be turned ON and OFF. When it is removed, the
power cannot be turned ON.
The on-off switch is shaped to make turning it ON
accidentally less likely.
In an emergency, it can be turned OFF by striking it
with the palm of the hand.
This feature is intended to help prevent unauthorized
and possible hazardous use by children and others.
• Insert key into switch.
• To turn the tool "On", insert finger under the switch
lever and pull end of lever out.
• To turn the tool "Off", push the lever in. Never leave
the tool unattended until it has come to a complete
stop.
• To lock the switch in the "Off" position, hold the switch
in with one hand and remove the key with the other
hand as shown.
WARNING: For your own safety, always lock the
switch "OFF" when machine is not in use. Remove
key and keep it in a safe place. Also, in the event of
a power failure (all of your lights go out) turn
switch off and lock it by removing the key. This will
prevent the tool from starting up again when the
power comes back on.
13. Stop Pin
For rabbeting operations greater than 1/8" deep, pin
can be pulled out to lower infeed table in 1/8" incre-
ments.
21