Operation - Ryobi CCG180L Operator's Manual

WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could re-
sult in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of at-
tachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this tool for the following purposes:
NOTE: Most of these applications require different types of
bits. Be sure to use the right bit for your tool.
Sealing cracks to keep your home's conditioned air inside
n
while keeping unconditioned air outside, increasing your
home's energy efficiency
n Filling holes and cracks before painting
n Creating a moisture barrier around areas that could be
damaged by water
n Sealing cracks to keep insects from crawling inside your
home
n Applying adhesive
CAUTION:
If at any point during the charging process none of the
LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. DO NOT insert another
battery. Return the charger and battery to your nearest
service centre for service or replacement.
LED FUNCTIONS OF CHARGER
LED WILL BE ON TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:
See Figure 2.
n Red LED on = Fast charging mode.
n Green LED on = Fully charged and in maintenance
charge mode.
n Green LED on = When battery pack is inserted
intocharger, indicates hot battery pack or that battery

OPERATION

pack is out of normal temperature range.
n Yellow and Green LEDs on = Deeply discharged
ordefective battery pack.
n No LED on = Defective charger or battery pack.
GREEN
LIGHT
YELLOW
LIGHT
CHARGING THE BATTERY PACK
Battery packs for this tool are shipped in a low charge
condition to prevent possible problems. Therefore, you
should charge it until the green LED on the front of the
charger comes on.
NOTE: Batteries will not reach full charge the first time they
are charged. Allow several cycles (operation followed by
recharging) for them to become fully charged.
CHARGING A COOL BATTERY PACK
If battery pack is within normal temperature range, the red
LED on charger will come on.
NOTE: If the charger does not charge the battery packunder
normal circumstances, return both the battery pack and
charger to your nearest Ryobi Authorised Service Centre
forelectrical check.
n Charge the battery pack only with the charger
provided.
n Make sure the power supply is normal household
voltage, 240 volts, 50 Hz, AC only.
n Connect the charger to the power supply.
n Place the battery pack in the charger aligning raised rib
on the battery pack with the groove in the charger. See
Figure 3.
n Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
n Normally the red LED on charger will come on.
Thisindicates the charger is in fast charging mode.
n Red LED should remain on for approximately 1
hour then the green LED will come on. Green LED
10
CHARGER
ACR1800
RED LIGHT
Fig. 2