Step 1: Connect your Cables Plug LinkStation’s power cord and Ethernet cable into the back of the LinkStation. Connect the power plug to a surge protector or power outlet. Plug the other end of the Ethernet cable into a hub, switch, or router on your local network.
Page 3
Step : Check your Connection • both LinkStation and the hub, switch, or PC are powered on, • the Ethernet cable is securely fastened to both devices, and • the Ethernet cable is not damaged. To verify, try using another Ethernet cable.
Step : Installing Software Insert the LinkNavigator CD into your computer’s CD- ROM drive. If Setup doesn’t launch automatically, you can launch it manually by clicking Start, then Run..When the Run dialog d:\setup.exe opens, type (where “d” is the drive letter of your CD-ROM).
Page 5
Next Continue pressing step through the installation. When installation is complete, you may close the installation window. Congratulations! Your LinkStation is ready to use. Turn to page 6 for more on using your LinkStation with a PC, or page 7 for more on using your LinkStation with a Mac.
Page 6
Until you change it, the GUI’s username is “admin” and the password is “password”. Consult your user manual for more information on the Buffalo NAS Navigator and the Settings Configuration GUI. Another way to access folders and data on your LinkStation is through the mapped driveletter ‘L’.
LinkStation’s settings. Until you change it, the GUI’s username is “admin” and the password is “password”. Consult your user manual for more information on the Buffalo NAS Navigator and the Settings Configuration GUI. Share Clicking...
~3.5 lbs Operating Temperature: 41-95˚ F; 20-80% non-condensing Technical Support Buffalo Technology offers free technical support. See the back page of this quick start guide for contact information. Please also visit the web site at http://www.buffalotech.com. FCC Warning This device complies with part 15 of the FCC Rules. Operation is...