Service Of The Binding; Annual Binding Check; Care And Service; Repairs - Diamir Eagle Experience Freeride Pro Service Manual

7

Service of the binding

7.1

Annual binding check

the binding must be checked and if necessary readjusted before each new season by a qualified specialist dealer:
• Adjustment to the boot and DIN value setting to the body see chapter 5
• Check function see chapter 6
• Care and service see chapter 7.2
7.2

Care and service

to extend durability close the automatic heel system when storing the binding (over summer).
After alpine touring and/or skiing store the skis in a dry and warm room. this prevents the binding mechanism from icing up and
corrosion.
When transported protect the binding from dirt and salt.
remove all kind of material (e.g. dirt). If the binding is dirty, clean it with a damp cloth or rinse it carefully. If too much water or pressure
is used the grease may be washed out.
Check the mounting screws (12) annually and tighten them if necessary.
If needed service the following parts with a grease or oil spray suitable for synthetic materials:
• the surface between heel piece (2) and the heel support (Picture 7.2 A)
• through the aperture in the rear zone of the central rail (Picture 7.2 B)
• In the zone of the set screw for the lateral release (21) (Picture 7.2 C)
• Between (sliding) base plate (15/16) and hinge support (13) (Picture 7.2 D)
Picture 7.2 a
7.3

repairs

Any repairs must be carried out by a specialist dealer or by the manufacturer.
Use the Service Documentation of the current season. this includes lists of spare parts of each model, views and instructions of repair.
If you do not have the current documentation, ask your distributor or the manufacturer.
Picture 7.2 B
DIAMIr Service Manual for specialist dealers
Picture 7.2 c
13
Picture 7.2 D
www.diamir.com