Advertisement
BT Home Monitor Keypad
Installation and User Guide
Step 3 – Wall Mounting The Keypad
If you wish to mount the Keypad on a wall surface, use
these instructions.
1. Hold the bracket against the wall and mark the drill
points through the two screw holes.
2. Drill two holes where you have marked the wall.
3. Insert the wall plugs.
4. Screw the bracket to the wall with the screws provided.
5. The Keypad slides into the bracket and the clips hold
it in place.
Step 4 – Test The Keypad
1. Stand about 3m away from the Control Panel and turn
the system ON by pressing the
2. Enter your User Code (if you have not selected a
personal PIN number this will be the default setting –
2580).
3. Check the Keypad LED lights green with each button
press. If the command is successful you will hear a
single beep and the LED will turn red.
4. The ON indicator light should appear on the Control
Panel. The panel will state aloud, "Switching on house,
please exit now" and the exit delay beeps will begin.
5. Switch the system OFF by pressing the
The ON indicator light on the Control Panel should go
out and the display should revert to READY.
BT Home Monitor Keypad VP – Edition 08 – 21.03.03
VP
ON
button.
OFF
button.
Downloaded from www.ukpanels.com
Usage
You can now use the Keypad buttons instead of the
Control Panel to switch your BT Home Monitor VP1000
on and off. The Keypad is also equipped with panic
button functions to allow people at home to send
emergency, help and fire alerts.*
Keypad Buttons And Functions
Help alarm
Emergency alarm (Press together)
FUNCTION
PRESS
Switch House ON
Turns your system on fully when you want to leave your house.
HOME
Switch Home ON
Turns on selected sensors so you have protection but can still
move around indoors. See Section 3 of the main User Guide
for more information.
OFF
Switch OFF
Turns your system off, except for 24-hour sensors which will
continue to function.
Help Alarm
Sends a help message to all your BT Home Monitor contacts.
Fire Alarm
Sounds the internal siren and sends a fire message to all your
BT Home Monitoring contacts.
Emergency Alarm
Sounds the internal siren and sends an emergency message
to all your BT Home Monitoring contacts.
Status Report
Gives a system status report at the Control Panel.
LIGHT
Light
This function is not operational. Reserved for future devices.
2
Indicator LED
2
5
8
0
Fire alarm
ON
Then enter USER PIN
Then enter USER PIN
Then enter USER PIN
Hold down for 2 seconds
Hold down for 2 seconds
+
Hold down for 2 seconds
Advertisement
