BT Home monitor keypad Installation And User Manual

BT Home Monitor Keypad
Installation and User Guide
Introduction
The BT Home Monitor Keypad acts as a wireless remote
control for your BT Home Monitor VP1000 system.
Carry with you around the home to turn your security
system on and off, or change settings, at the touch of
a button. The panic button functions allow you to call for
help in an emergency, ensuring that nominated contacts
receive alerts by telephone, text message and e-mail.*
You can have 2 Keypads registered with the Control Panel.
They provide a useful way to turn your system on and off
if your Control Panel is located somewhere other than
your usual entry and exit point.
Inside The Box
• 1 Wireless Keypad (Battery Included)
• Mounting Equipment
• Installation Guide
Before You Begin
Be sure you have set up your BT Home Monitor VP1000
system according to the instructions shown in the main
User Guide.
Before you proceed, check that your Control Panel says
BT HOME MONITOR or READY. If it does not, please
consult the troubleshooting section of the main User Guide.
Note that only the MASTER CODE owner can add an
accessory.
BT Home Monitor Keypad VP – Edition 08 – 21.03.03
VP
0
Downloaded from www.ukpanels.com
Installation
To add a new Keypad, follow these instructions.
Step 1 – Insert The Battery
1. Remove the wall mounting bracket from the Keypad
by pushing downward.
2. Slide down the battery cover.
3. Insert the battery (observing polarity + and –).
4. Replace the battery cover.
Step 2 – Register The Keypad
At the Control Panel, follow these instructions:
PRESS DISPLAY
NEXT
Until the display shows SYSTEM PROFILE.
Enter your MASTER CODE – if you have not
SHOW / OK
selected a personal PIN number, this will be the
default setting – 2580.
NEXT
Until the display shows ADD / DEL KEYPAD 1.
SHOW / OK
Display shows 1-WAY KP NO:–
Enter the Keypad number you want e.g. 1,
or press NEXT to find the next available
Keypad location.
SHOW / OK
Display shows ACTIVATE NOW.
Press the ✱ button (next to
for two seconds. You will hear a confirmation
melody.
Display shows KEYPAD NO: (number), e.g. I.
The Keypad is now registered. Choose either:
NEXT
To move to the next Keypad. Or:
Three times, then <OK> to exit and return
HOME
to READY.
Please remember to update your personal online account
with this information so that your monitoring service can
report information accurately.
1
0
) on the Keypad