Product Overview - Toro Power Max 726 OE Operator's Manual

Figure 14
The machine should move rearward. If the machine
does not move or moves forward, complete the
following:
A. Release the traction lever and stop the engine.
B. Disconnect the trunnion from the speed selector
lever (Figure 5).
C. Turn the trunnion downward (clockwise) on the
speed control rod (Figure 5).
D. Connect the trunnion to the speed selector lever
(Figure 5).
4. Release the traction lever.
5. Move the speed selector to the Position 1; refer to
Operating the Speed Selector.
6. Squeeze the left hand (traction) lever to the hand-grip
(Figure 14).
The machine should move forward. If the machine
does not move or moves rearward, complete the
following:
A. Release the traction lever and stop the engine.
B. Disconnect the trunnion from the speed selector
lever (Figure 5).
C. Turn the trunnion upward (counterclockwise) on
the speed control rod (Figure 5).
D. Connect the trunnion to the speed selector lever
(Figure 5).
7. If you made any adjustments, repeat this procedure
until no adjustments are required.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable
(refer to Checking and Adjusting the Traction Cable) or
take the machine to an Authorized Service Dealer for
service.

Product Overview

1. Hand-grip (2)
2. Auger/impeller lever
3. Speed selector lever
4. Quick Stick™ discharge
chute control
5. Traction lever
6. Fuel tank cap
7. Engine oil fill tube/dipstick 15. Snow cleanout tool
8. Chute deflector
g018888
1. Choke
2. Ignition switch
3. Fuel shutoff valve
4. Throttle
12
g018887
Figure 15
9. Discharge chute
10. Scraper
11. Auger
12. Skid (2)
13. Electric starter button
14. Electric starter plug-in
Figure 16
5. Recoil starter
6. Oil drain plug
7. Primer