Garmin Gpsmap 196 Quick Start Manual page 11

To attach the GPSMAP 196 to the mounting base:
1. Ensure that the locking lever is in the unlocked position and depress the release tab.
2. Slide the disk located at the bottom of the mounting bracket into the base until it clicks into place.
Swivel the unit to the right or left until the desired angle is achieved. Slide the locking lever to the
locked position to secure the unit to the base.
Attaching the unit to
the mounting base
To remove the GPSMAP 196 from the mounting base:
1. Slide the locking lever to the unlocked position and depress the release tab.
2. Slide the unit over the release tab and out of the base.
Removing the unit
from the mounting base
To remove the mounting bracket from the GPSMAP 196:
1. Holding the unit in place, lift and pull the protruding tab on the left-hand side of the bracket (front
view) away from the unit so as to dislodge the two short tabs from their grooves, and pull the bracket
out and away from the unit.
Slide the unit in the base
while holding the
release tab down
Release tab
Slide the unit out and
away from the base
while holding the
release tab down
Release tab
Quick Start
Vehicle Dash Mount Instructions
Lift and pull the
protruding tab in
order to dislodge the
two short tabs from
their corresponding
grooves.
Removing the Mounting Bracket
11