Yamaha YDRA Owner's/Operator's Manual page 40

JW1
MAINTENANCE
Transaxle Oil
To check transaxle oil level:
1. Place the golf car on a flat, level
surface.
2. Remove seven plastic rivets 1
and two bolts 2, and remove the
bag holder insert.
3. Place an oil pan under the
transaxle case.
4. Clean area around servicing plug 4.
5. Using an 8 mm hex wrench,
remove transaxle oil servicing
plug located on the rear of the
Y-1215
transaxle case.
6. Transaxle oil should be at the top
of the oil servicing hole or just
beginning to run out of hole.
NOTICE
Do not allow foreign material to
enter transaxle. Serious transaxle
damage can result.
Y-1213
7. If needed, add Yamalube Shaft
Drive Gear Oil until it is at the top
of the plug hole or just beginning
to run out of servicing hole.
TIP
The YDRA Golf Car is equipped with
an internal wet brake. Use of oil other
than Yamalube Shaft Drive Gear Oil
will cause brake noise.
8. Install the transaxle servicing
plug and tighten to 14-19 Nm,
1.4-1.9 m•kg (120-168 in•lb).
9. Install the bag holder insert 3
and secure with two bolts 2 and
seven plastic rivets 1.
1
2
3
4
5
6
7
8
9
10
11
8-10