JEFF ROWLAND 112 Owner's Manual page 9

Amplifier Front and Rear Panel Function Controls Amplifier Front and Rear Panel Function Controls
B B
efore attempting any system interconnection, please familiarize yourself with the front and rear panel controls of the Model 112 Stereo Power
Amplifier. The descriptions below refer to the diagrams above.
Front Panel Front Panel
1 1
FRONT PANEL STANDBY/POWER BUTTON: Press this button to
operate the amplifier. Press again to place the amplifier in
Standby mode. The small orange POWER INDICATOR LED will
illuminate when the amplifier is operational. When the POWER
INDICATOR LED is not illuminated, all amplifier inputs are muted
and internal circuitry reverts to power-saving (Standby) mode.
Anomalous operating conditions will place the amplifier in
Standby mode and will prevent the amplifier from being
switched back on again until such a condition is eliminated.
To avoid spurious noises, the amplifier should never be turned on
if the inputs on the rear panel are not connected.
Note: All ON/OFF power switching should be initiated ONLY with Note:
this button. The amplifier should never be disconnected from
AC power without first placing the amplifier in Standby mode.
Rear Panel Rear Panel
(Note: If desired, the switch described below can be switched while
the amplifier is operational and playing music.)
1 1
INPUT SELECT SWITCH: This switch selects either the unbalanced
RCA inputs or the balanced XLR inputs. Note:
position is selected, pin 2 of the XLR is shorted to pin 1.
Control Control
Functions Functions
Note: When the RCA