SECTION 2 CONTROLS AND TERMINALS
2-1, Front Pane!
(ij VOL/POWER
Power ON-OFF switch and volume control are combined.
Turning the control fully counterclockwise will turn the
power OFF. Clockwise rotation will increases the volume.
®
SQUELCH
The squelch control is used to eliminate noise during no-
signal time, Normally, this control is adjusted clockwise
until the noise disappears and the Center Tuning indicator
goes off (threshold level). For scan operation, this control
must be set to the threshold point.
® LCD and Indicator Group
ri ri
iii I ri i
rrrri
H
[1T
jr
____
MHz
I
-
REV
C. TUNING
PRIO
-
_
1
3
5
7
9
a) TX shift indicators:
EJBy pressing the
key on the keyboard, the
indica-
tor will light in sequence to show transmit frequency is
switched down 600 KHz from the receive frequency.
By pressing the
key on the keyboard, the E indica-
tor will light in sequence to show the transceiver is
operating in the simplex mode.
EJBy pressing the
key on the keyboard, the
Jindica-
tor will light in sequence to show transmit frequency is
switched up 600 KHz from the receive frequency.
b) LiJ indicator:
By pressing the TONE pushbutton the four digit frequency
display changes to show which of three preset subaudible
frequency channels is selected. iJ does not display at FO
(no tone). TU-79 option required.
c)
1 indicator lights when scan operation is in pro-
gress.
d) This section displays either frequency in four digit
(146.520 MHz is displayed as
6.520 ), or one of four
subtone conditions (Fl -3, or 0, no tone).
TR795O/793O
9