Epson EB-460i User Manual page 105

Problem Solving
No sound can be heard from the microphone
Check
Is the microphone connected correctly?
Is the Mic Input Volume turned down too low?
The remote control does not work
Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Is the remote receiver set correctly?
Are the batteries dead or have the batteries been inserted in the
wrong direction?
I want to change the language for messages and menus
Check
Change the language setting.
Disconnect the cable from the Microphone (Mic) input port, and then reconnect the cable.
Adjust the Mic Input Volume so that sound can be heard. s Settings Menu - Mic Input Level
Point the remote control towards the remote receiver during operation.
Operating range s Quick Start Guide
The operating range for the remote control is about 6 m. s Quick Start Guide
Set the projector up in a location where strong light does not shine onto the remote receiver. Alternatively, set the remote
receiver affected by light to Off from Remote Receiver in the Configuration Menu. s Settings Menu - Remote
Receiver p.76
Check the Remote Receiver setting from the Configuration Menu. s Settings Menu - Remote Receiver
Insert new batteries in the correct direction. s
Change the Language setting from the Configuration Menu. s
Remedy
Remedy
p.110
Remedy
p.78
105
p.76
p.76