EchoStar DTVPal User Manual page 41

TV G
UIDE
TV Guide On Screen or Guide Plus Setup
You only need to perform the following steps if you have a TV, DVD recorder,
or VCR that includes TV Guide On Screen or Guide Plus. If you do not have a
TV Guide On Screen or Guide Plus device, you will be able to use the built-in
Program Guide in your DTVPal DVR.
If you are currently using TV Guide On Screen or Guide Plus in your analog
TV, DVD recorder, or VCR for over-the-air TV reception (not cable or satellite
service), you will need to change your TV Guide On Screen/Guide Plus setup
option to continue receiving your TV Guide On Screen/Guide Plus listings.
The steps provided walk you through the changes you need to make to
continue receiving show listings when your DTVPal DVR is connected to your
Guide-enabled product.
For more detailed instructions or updated support information, refer to
www.tvgos.com/support.
Getting Started
To set up the TV Guide On Screen to communicate with your DTVPal DVR,
you'll need:
• G-LINK Cable—this cable is required to continue receiving TV Guide
On Screen/Guide Plus listings in your Guide-enabled product.
The G-LINK cable was shipped with your original TV Guide On Screen/
Guide Plus-enabled TV, DVD recorder, or VCR. If you no longer have
the G-LINK cable, visit www.tvgos.com/support.
• Substitute ZIP Code—you will need the five-digit code associated with
your broadcast area. During setup, you will enter the Substitute ZIP
Code in place of your actual ZIP code. These codes are provided on
page 38 of this User's Guide.
Setting Up Your DTVPal DVR
1. Connect your DTVPal DVR using the instructions on page 2. You
should have connected the TV S
corresponding input on your Guide-enabled TV, DVD recorder, or VCR.
Customizing Receiver
O or A /V
ET UT UDIO IDEO
TV Guide
output to the
33