Programming Your Remote Control; Setting Up Using Device Codes Scan - EchoStar DTVPal User Manual

Customizing Receiver

Programming Your Remote Control

Setting Up Devices by Entering Codes
You can set up the remote to control other devices using the device codes
listed on page 27.
1. Turn the device on.
2. Find the brand name in the tables.
3. Press and hold the mode button for the device until all the mode buttons
4. For AUX mode, press 0 for a TV, 1 for a VCR, or 2 for an audio tuner/
5. Using the NUMBER PAD, enter one of the three-digit device
6. Wait for three flashes of the mode light. If it doesn't, go back
7. Press POWER to turn off the device. If the device does not turn
8. Turn the device back on and try some other buttons to make sure they
9. If the code doesn't work, repeat steps 3 through 7 with the next device
10. If you can't find a code that works, then try Setting Up Using Device

Setting Up Using Device Codes Scan

1. Turn the device on.
2. Press and hold the Mode button for the device until all the Mode buttons
3. Press POWER.
4. Press the UP (or DOWN ARROW, but not both) until the
5. Wait for three flashes of the mode light. If it doesn't flash three times,
6. Turn the device back on and test to make sure it works
26
light up.
amplifier.
codes for your brand from the table. Then press POUND (#).
to step 3.
off, go to step 8.
work. If the code works for other buttons, stop here.
code from the tables.
Codes Scan.
light up.
device turns off. Then press POUND (#).
then go back to step 3.
with other remote-control buttons, like VOLUME.