Advertisement
Adjustment
Make this adjustment if the tonearm doesn't return auto
matically to the arm rest, or if it returns before the tune ends.
1. Adjust to the desired automatic-return position.
2. Check to be sure the automatic-return position is correct.
If there is no automatic return.
Auto-return adjustment screw
This adjustment is preset at the factory. This adjustment should
not be necessary unless the cartridge or stylus is changed.
1. Set the cueing control to "
.:z ".
2. Move the tonearm to a position above the disc.
3. Adjust the stylus tip positon.
T=--'------
Adjustment screw
ment
Repla
If noise is heard from new discs, the stylus is probably worn.
Replace it with a new one.
(Refer to the operating instructions of the cartridge.)
The plug-in type of cartridge is already designed to match this
unit in every respect: weight, correct stylus pressure, stylus tip
position, center of gravity, etc. This means that there's no longer
any need for troublesome connection of lead wires or
adjustment of the stylus pressure.
(Refer to page 3.)
When the platter rotates, the strobe marks form a stripe pattern
according to the rotation speed and the frequency of the power
supply.
The platter speed is correct when the stripe pattern of the
stroboscope appears to be stationary while the platter is
moving; adjust the speed if the stripes appear to be moving.
Speed
Power supply frequency
e
~~
~ ~
45 rpm
torSO Hz use
I
t=.
!~-;~~rpm ;=~~~~~~::n
countries)
~
-
- - -
-
33-1/3 rpm (For U.S.A. and CANADA)
If stripe pattern
If stripe pattern
seems to move to
seems to move to
the left (platter
the right (platter
speed is too fast)
speed is too slow)
Platter speed will
Platter speed will
decrease.
increase.
+.,....... -
+~-
~
~
pitch adj.
pitch adj.
Maintenance
Use a soft brush or similar material to gently remove the dust.
Thoroughly clean your discs occasionally with a high-quality
disc cleaner.
To clean this unit, use a soft, dry cloth.
If the su rfaces are extremely dirty, use a soft cloth, dipped into a
soap-and-water solution or a weak detergent solution.
Wring the cloth well before wiping the unit.
Wipe once again with a soft, dry cloth.
Never use alcohol, paint thinner, benzine, nor a chemically
treated cloth to clean this unit.
Such chemicals may damage the finish of your unit.
- 5
Hide quick links:
Advertisement
