Yamaha 212SS Owner's Manual page 66

3
O
PERATION
If the stern light is not installed,
remove it from the storage area,
lift the socket cover, and install it
into the socket to check operation.
Horn
Press the horn switch  to be sure the
horn operates.
30
20 40
MPH
10 50
4
3 5
60
0
2 6
RPM
x1000
1 7
0 8
M T
BLOWER
Engine Shut-Off Switch
4
5
3 BILGE
2 6
RPM
x1000
1 7 HORN
0 8
NAV/ANC
M T
COURT
LTS
 Engine Shut-off Switch
 Clip with Cord
First, place the boat in the water to pro-
vide adequate engine cooling. Start the
engine, and then remove the engine
shut-off switch clip, and verify that the
engine stops.
Refer to pages 3-15 to 3-17, "STARTING
THE ENGINES," for information on
proper operation of the starter switch.
Cooling-Water Pilot Outlets
Check that water comes out from the
pilot outlets while engine is running in
the water. Refer to page 2-13 for correct
operation of the device.
TIP: It may take up to 20 seconds for
water to reach the pilot outlets when
first launching the boat. The amount
and force of the exiting water will vary
with engine rpm.
A continuous flow of water from
the pilot hole shows that water is
flowing through the engine cooling
passages. If water is not flowing out
of the pilot hole during operation,
do not continue to run the engines.
3-10