Sony DMX-R100 Operating Instructions Manual page 61

4
Press the original Page selectable button.
The channels of the original page appear again.
5
Press the ACCESS button of the source channel.
The blinking ACCESS button stops blinking and
stays lit and the copying operation is cancelled.
Notes
• When the source channel is on a different page, if
you press the ACCESS button without knowing it,
the settings of the source channel are copied to that
channel. Make sure to clear the copying function of
the source channel.
• While using the automation, you cannot perform a
copying operation. Also, switching on the
automation will cancel active copying.
• The channel name is copyed regardless of the
function button selection 5.
ZERO section
On the DMX-R100, a "Zero" function is provided for
setting the specified values to the desired value.
4 Zero tab
When this tab is selected, you can set the "Zero"
functions which means they will return to their default
settings.
5 Function buttons
When the Zero tab is lit, the "Zero" function can be
executed on the following subjects. Touch and light
the desired buttons.
• TRIM • DLY (delay)
• EQ/FIL •DYNA
• CH FDR (CH fader)
• PGM ASGN (PGM assign)
• MTR FDR (MTR fader)
• MTR ASGN (MTR assign)
• SURN PAN(surround pan
• AUX NOB (AUX knob)
• AUX BT (AUX button)
The CUT GP (cut group) and FDR GP (fader group)
buttons are deactivated when using the "Zero"
function.
Executing the "Zero" function
1
2
3
The DESTINATION CHANNEL box shows the last
channel to which the "Zero" function was executed.
FADER COPY section
The desired fader level, PAN and CUT of the channels
or the MTR sends can be copied to the MTR send,
AUX send or other channel faders.
CH b MTR section: The source channel faders are
selected by the INDV, 1-24 or 25-48 buttons. The
destination faders are the MTR send faders of the
selected channels.
• ST MODE
CH b AUX section: The source channel faders are
• CH PAN
selected by the INDV, 1-24 or 25-48 buttons. The
• CH CUT
destination faders are the AUX send faders selected by
• MTR PAN
the AUX buttons.
• MTR CUT
MTR b AUX section: The source channel faders are
the MTR send faders of the channel selected by the
INDV, 1-24 or 25-48 buttons. The destination faders
are the AUX send faders selected by the AUX buttons.
AUX button: Selects the destination AUX send
faders.
INDV button: To select the desired source fader
individually, touch to light this button (green). Then,
on the control panel, press and release the desired
channel (or MTR) ACCESS buttons down. The source
Touch the Zero tab on the window.
Select the functions to be executed using the
"Zero" function by touching the Function buttons
on the window.
Press and release the ACCESS button of the
channel to perform the "Zero" function.
CH b AUX section MTR b AUX section
CH b MTR section
61
Chapter 3 Menu