Table of Contents
Advertisement
The White Balance Adjustment should be
performed when replacing the LCD Panel
or Digital Main CBA.
3. White Balance Adjustment
Purpose: To mix red, green and blue beams correctly
for pure white.
Symptom of Misadjustment: White becomes bluish
or reddish.
Test Point Adj. Point
[P
/
]
Screen
buttons
M. EQ.
Pattern Generator,
Color analyzer
To avoid interference from ambinent
light, this adjustment should be
performed in a dark room.
Perpendicularity
L = 3 cm
INPUT: WHITE 70%, 40%
1. Operate the unit for more than 20 minutes.
2. Input the White Raster(70%=70IRE, 40%=40IRE).
INPUT SIGNAL
0IRE
Low
Light
100IRE
40%=40IRE
3. Set the color analyzer to the CHROMA mode and
bring the optical receptor to the center on the
LCD-Panel surface after zero point calibration as
shown above.
Note: The optical receptor must be set
perpendicularly to the LCD Panel surface.
4. Enter the Service mode. Press [
remote control unit and select "C/D" mode.
Mode
Input
White Raster
[VIDEO1]
(APL 70%)
C/D
or
(APL 40%)
Spec.
x= 0.286 ± 0.005
y= 0.295 ± 0.005
Figure
Color Analyzer
0IRE
Hight
Light
100IRE
70%=70IRE
-] button on the
5. [CUTOFF]
Press [1] button to select "COR" for Red Cutoff
adjustment. Press [3] button to select "COB" for
Blue Cutoff adjustment.
[DRIVE]
Press [4] button to select "DR" for Red Drive
adjustment. Press [6] button to select "DB" for Blue
Drive adjustment.
6. In each color mode, press [P
adjust the values of color.
7. Adjust Cutoff and Drive so that the color
temperature becomes 9200°K (x= 0.286 / y= 0.295
±0.005).
8. To cancel or to exit from the White Balance
Adjustment, press [BACK] button.
5-3
/
] buttons to
A0CN0EA
Hide quick links:
Advertisement
Table of Contents
