Table of Contents
Advertisement
Attaching the function knob to the display
•
The function knob can be attached to any screw hole on the display.
•
Align the screw holes of the display and function knob. Next, fasten using the screw.
Note
Using a screw other than the one supplied can damage the display.
Detaching the function knob
Hold the area marked in the
picture.
Rear
Note
See the "Connections" section for details about cable connections. The LCD Display's configuration
at the back may vary slightly depending on the model.
Introduction
Push the areas marked.
IR OUT
Receives a signal from the remote control and
outputs the signal through Loopout when a re-
movable sensor board is connected.
CONTROL IN
Connects to the function (Power/Source) control
buttons and receives the light sensor signal and
remote control's IR signal.
DVI OUT (LOOPOUT)
Hold the areas marked, and
lift the function knob.
Advertisement
Table of Contents
