Watching The Picture; Switching The Input Signal - Sony PFM-42V1 Operating Instructions Manual

Watching the Picture

Watching the Picture
Before you start
• Power on the display.
• Power on the connected equipment and play a video
source.
• To display the input signal information and Picture
Mode on the screen when turning on the power or
switching the input signal, set "Display" in the
Custom Setup menu to On.
• To select the language of the menus, see "Selecting
the On-screen Language" on page 42 (GB).

Switching the Input Signal

1
Press MENU.
The main menu appears on the screen.
P i c t u r e / S o u n d
P i c t u r e M o d e :
A d j u s t P i c t u r e
A d j u s t S o u n d
S e l e c t
2
Press M/m to move the cursor (yellow) to "Input
Select" and press ENTER or ,.
The Input Select menu appears on the screen.
I n p u t S e l e c t
I N P U T 1 R G B
I N P U T 1 Y U V
I N P U T 2 D V I
V I D E O C O M P O S I T E
V I D E O Y / C
S e l e c t S e t
3
Press M/m to move the cursor (yellow) to the
input source to be displayed and press ENTER.
INPUT1 RGB: Selects the signal (analog RGB)
input to the INPUT1 connectors.
INPUT1 YUV: Selects the signal (component)
input to the INPUT1 connectors.
INPUT2 DVI * : Selects the signal (digital RGB)
input to the INPUT2 connectors.
VIDEO COMPOSITE: Selects the signal input
to the COMPOSITE IN of the VIDEO
connectors.
VIDEO Y/C: Selects the signal input to the Y/C
IN of the VIDEO connectors.
* When using the PFM-42V1N, you cannot select
26
(GB)
C o n t r o l
S t a n d a r d
S e t / E n d
ENTER MENU
E n d
ENTER MENU
this item because this model is not equipped with
the INPUT2 connectors.
When a Component/RGB Input Adaptor BKM-
V11 or an RGB/Component Active Through
Adaptor BKM-V12 is installed
OPTION YUV: Selects the signal (component)
input to the YUV/RGB IN connectors.
OPTION RGB: Selects the signal (analog RGB)
input to the YUV/RGB IN connectors.
The selected input signal appears on the screen.
Color system or horizontal/vertical frequency
Signal type
O P T I O N R G B
1 0 2 4 7 6 8 / 6 0
S t a n d a r d
Picture mode
You can switch the input signal using the supplied
Remote Commander.
Notes
•We recommend input source video equipment
equipped with a TBC (time base corrector). If the
display receives a signal without TBC, the picture
may disappear due to disturbance of the sync signal.
•If signals of the same format are input from multiple
systems, the Picture Quality setting will default to
the most recently set value (Only when the signal
formats are identical).