Electrolux EWB 95205 W User Manual page 11

1
2
Untying
A B
C
D
B
2
1
Keep the transit
bolts for when you
move the appli-
ance.
Water supply
90 90 90
O O O
A
1 B
2
D
To install the appli-
ance at the same
level as neighboring
furniture, cut these
plastic pieces.
In case of necessity
move the inlet hose
in the direction
shown on picture.
To make this loose
the inlet hose ring
nut and position the
inlet hose down-
wards as drawn on
picture. Tighten the
ring nut back and
make sure there are
no leaks.
Drainage
Fit the U-piece on
the drainage hose.
Place everything in a
drainage point (or in
a sink) at a height of
between 70 and 100
cm. Ensure it is posi-
tioned securely. Air
must be able to en-
ter the end of the
hose, to avoid any risk of siphoning.
The drain hose must never be stretched. If
it is too short, contact an engineer.
Electrical connection
This washing machine must only be con-
nected in single-phased 230 V. Check the
fuse size: 13 A for 230 V. The appliance
must not be connected with an extension
lead or multi-plug adaptor. Ensure that the
plug is earthed and that it is in accordance
with current regulations.
Positioning
Position the appliance on a flat and hard
surface in a ventilated location. Ensure the
appliance does not come into contact with
the wall or other furniture. Accurate levelling
avoids vibrations, noise and prevents the
appliance from moving when running.
electrolux 11
Open the water inlet
tap. Check there
are no leaks. The
water inlet hose can
not be extended. If
it is too short,
please contact the
after-sales service.
min
max
70 cm
100 cm