Desa CDCFTNA Owner's Operation page 19

iNsTallaTioN
Continued
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
Remote-Ready Models Only
(HRC100 Series & HRC200 Series)
Installing Receiver
1. Disconnect wires from the control valve (see
Figure 29) .
2. Locate the battery clip mounted on the back
of the receiver (see Figure 30).
3. Slide 9-volt battery (not included) through the
clip.
4. Attach the terminal wires to the battery (see
Figure 30).
5. Connect wires from remote receiver to control
valve as shown in Figure 31.
6. Install remote receiver unit onto remote/
blower bracket using screws provided (see
Figure 31).
Figure 29 - Disconnecting Wires From
Control Valve
Receiver
9-Volt
Battery
Figure 30 - Attaching Battery to Receiver
White Wire to
TH Terminal on
Control Valve
Remote
Receiver
Figure 31 - Installing Remote Receiver
111244-01G
Terminal
Wires
Battery Clip
Red Wire to
TPTH Terminal on
Control Valve
www.desatech.com
Installing 9-Volt Battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery (not includ-
ed). Place battery into the battery housing.
3. Replace battery cover onto remote control unit.
Terminal
Wires
9-Volt
Battery
Figure 32 - Installing Battery in Hand-
Held Remote Control Unit
OPTIONAL WALL MOUNTED
THERMOSTAT - GWMT1
(Remote-Ready Models Only)
WARNING: Read and fol-
low installation instructions.
Installation should be done by
a qualified installer familiar with
low-voltage wiring procedures.
WARNING: Do not connect
this thermostat to any electrical
source! Electrical shock and/or
fire hazard will occur.
1. Remove jumper wire from control valve (see
Figure 39).
2. Connect one terminal of 25 ft. wire to the
"TH" terminal on the control valve. Connect
the other terminal to the "THTP" terminal on
the control valve. See Figure 33.
Figure 33 - Connecting Wire Terminals
Remote
Control Unit
Battery
Cover
Battery
Housing
Control Valve
To Wall
Thermostat
or Switch
To Wall
Thermostat
or Switch
19