1. WORK AREA Definitions: Safety Guidelines a. Keep work area clean and well lit. Cluttered and dark areas invite accidents. b. Do not operate power tools in explosive atmospheres, such as in the The definitions below describe the level of severity for each presence of flammable liquids, gases or dust.
e. Do not overreach. Keep proper footing and balance at all times. This b. Recharge only with the charger specified by the manufacturer. A charger enables better control of the power tool in unexpected situations. that is suitable for one type of battery pack may create a risk of fire when used with another battery pack.
WARNING stand upright on the battery pack but may be : Lens and bulb become hot easily knocked over. during use • The label on your tool may include the following symbols. The symbols and • During or immediately after use, don’t lay flexible floodlight flat on lens their definitions are as follows: surface.
To remove the battery pack from the tool, press the release button and firmly pull the FIG. 5 FIG. 4 battery pack out of the tool handle. Insert it into the charger (Fig. 2) as described in the charger section of this manual. Switch (Fig.
Dirt and grease may be removed from the This warranty does not apply to • Accessories exterior of the charger using a cloth or soft • Damage caused where repairs have been made or attempted by others. non-metallic brush. Do not use water or any •...