Intended Use; Assembly And Adjustments - DeWalt XR Li-Ion DCS355-XE Instruction Manual

FIG. 2
B
C
E
G

INTENDED USE

This oscillating multi-tool is designed for professional detail sanding, plunge cutting,
flush cutting, removal of excess materials and surface preparation applications.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
This oscillating multi-tool is a professional power tool. DO NOT let children come into
contact with the tool. Supervision is required when inexperienced operators use this
tool.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal injury, turn the tool off and
disconnect the battery pack before making any adjustments or removing/installing
attachments or accessories. An accidental start-up can cause injury.
WARNING: Risk of lacerations or burns. Do not touch the sharp edges of
accessories at any time. Do not touch workpiece or blade immediately after
operating the tool. They can become very hot. Handle carefully. Always allow
accessories and workpiece to cool before handling.
D
A
F
I H
Installing/Removing Accessories (Fig. 3–5)
TOOL-FREE ACCESSORY CLAMP
The DCS355 features a quick change accessory system. This allows for faster
accessory changes without the need for wrenches or hex keys like other oscillating
tool systems.
1. Grasp the tool and squeeze the accessory
clamping lever (C) as shown in Figure 3.
2. Clean any residual debris from the tool shaft
and the accessory holder.
3. Slide the accessory between the shaft (J)
and the accessory holder making sure the
accessory engages all eight pins on the
holder and is flush with the shaft.
4. Release the accessory clamp lever.
NOTE: Some accessories, such as scrapers and
blades, can be mounted at an angle if required as
shown in Figure 5.
FIG. 4
8
FIG. 3
C
FIG. 5
J