Table of Contents
Advertisement
SWITCH COVER AREA WIRING MANAGEMENT
POWER CORD/ON-OFF SWITCH REPLACEMENT
Removal
1. Remove the dust cover and switch cover to expose the electrical connections of the power cord, ON/OFF switch, and
wire cord.
2. Pull the power cord into the dust compartment in order to remove the strain relief (for power cord replacement) by
prying or cutting, remove the wire connectors, and wire tie, if present.
3. Remove the ON/OFF switch (for ON/OFF switch replacement) by depressing the switch retaining tabs while pushing
up out of the dust compartment at the same time.
4. Pull the power cord out of the dust compartment (for power cord replacement).
(Continued on p. 16)
DUST COMPARTMENT COMPONENT LOCATIONS
- 15 -
(Fig. 10)
(Fig. 11)
Advertisement
Table of Contents
