Related Manuals for DeWalt DCF880-XE
Summary of Contents for DeWalt DCF880-XE
- Page 1 INSTRUCTION MANUAL DCF880-XE 18 V CORDLESS 13 mm (1/2") IMPACT WRENCH DCF885-XE 18 V CORDLESS 6.35 mm (1/4") IMPACT DRIVER...
-
Page 3: Definitions: Safety Guidelines
The term “power tool” in the warnings refers to your mains-operated (corded) power Definitions: Safety Guidelines tool or battery-operated (cordless) power tool. 1) WORK AREA SAFETY The definitions below describe the level of severity for each signal a) Keep work area clean and well lit. Cluttered or dark areas invite accidents. word. -
Page 4: Electrical Safety
b) Use personal protective equipment. Always wear eye protection. Protective operation. If damaged, have the power tool repaired before use. Many equipment such as dust mask, non-skid safety shoes, hard hat, or hearing accidents are caused by poorly maintained power tools. protection used for appropriate conditions will reduce personal injuries. -
Page 5: Extension Cords
• Young children and the infirm. This appliance is not intended for use by young WARNING: We recommend the use of a residual current device with a residual children or infirm persons without supervision. current rating of 30mA or less. –... -
Page 6: Important Safety Instructions For All Battery Packs
• The label on your tool may include the following symbols. The symbols and their or metal buildings in summer). For best life store battery packs in a cool, dry location. definitions are as follows: NOTE: Do not store the battery packs in a tool with the trigger switch locked V .... -
Page 7: Important Safety Instructions For All Battery Chargers
Important Safety Instructions for All Battery Chargers • Do not place any object on top of the charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal SAVE THESE INSTRUCTIONS: This manual contains important safety and operating heat. -
Page 8: Charge Indicators
Indicator Light Operation NOTE: This could also mean a problem with a charger. PROBLEM POWERLINE PACK CHARGING Some chargers have a problem powerline indicator. When the charger is used with some portable power sources such as generators or sources that convert DC to AC, the PACK CHARGED charger may temporarily suspend operation, flashing the red light with two fast blinks followed by a pause. -
Page 9: Storage Recommendations
FIG. 2 be kept away from charger cavities. Always unplug the charger from the power DCF880-XE supply when there is no battery pack in the cavity. Unplug the charger before attempting to clean. 7. Do not freeze or immerse the charger in water or any other liquid. -
Page 10: Operation
Belt Hook and Bit Clip (Fig. 2) To install the battery pack (F) into the tool handle, align the battery pack with the rails inside the tool’s handle and slide it into the handle until the battery pack is firmly WARNING: To reduce the risk of serious personal injury, turn tool off and seated in the tool and ensure that it does not disengage. - Page 11 The center position of the control button locks the tool in the DCF880-XE off position. When changing the position of the control button, be sure the trigger is Place the switch in the locked off (center) position or remove battery pack before released.
-
Page 12: Maintenance
• Larger bolt diameters generally require higher fastening torque. Fastening To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment torque will also vary according to length, grade, and torque coefficient. (including brush inspection and replacement) should be performed by certified service centers or other qualified service organizations, always using identical •... - Page 16 The battery voltage is nominal, it can measure above or below depending on the state of charge. Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia • 1800 444 224 (Aust) or 0800 339 258 (NZ) www.dewalt.com.au • www.dewalt.co.nz (MAY12) Part No. N175308 DCF880-XE, DCF885-XE Copyright ©...