Advertisement
STAND-BY/MUTE
To mute the speaker system, press the
c9
button located on the
control pod or wireless remote. The LED on the control pod will turn
off. To un-mute, perform either command again.
Note: While in stand-by or mute mode, the system continues to receive
power. To completely shut down the unit unplug the unit from the
wall.
RESET
The button marked with the word "reset" on the wireless remote
restores master volume, bass, treble, as well as center and rear volume
to original factory settings.
You can also reset the system by pressing the stand-by button
c9
on
the controller for 5 seconds.
IPOD/MP3 PLAYER JACK
The iPod or MP3 player jack is located on the side of the control pod.
Use it to connect any audio source that has a stereo 3.smm plug.
Caution: Make sure the audio source features a line-out jack. This will
ensure that the output is not amplified. Check the owner's manual for
your audio device for more information.
HEADPHONES
The headphone jack is located on the side of the control pod. Use it to
connect any stereo headphones with a 3.smm plug.
Note: When headphones are connected, the speaker system is muted.
Altec Lansing's superior sound comes from our patented Dynamic EQ technology, which utilizes custom-built, high-fidelity drivers, state-of-the-
art equalization circuitry, and a harmonious mix of the following specifications:
Sound Pressure Level (SPL):
101 dB
Total Continuous Power:
89 Watts RMS
• Front Speakers:
12 Watts/channel
@
4 ohms
@
10% THO
@
150 Hz - 20 kHz
2 Channels Loaded
• Rear Speakers:
12 Watts/channel
@
4 ohms
@
10% THO
@
150 Hz - 20 kHz
2 Channels Loaded
Frequency Response:
Signal to Noise Ratio
@
1 kHz input:
Drivers (per satellite):
Subwoofer:
30 Hz - 20 kHz (-10 dB)
> 75 dB
One 40mm mid-range driver and
one 18mm high-end tweeter
Two 6.5" long-throw woofers
in isobaric configuration
• Center Speaker:
• Subwoofer:
13 Watts
@
4 ohms
@
10% THO
@
150 Hz - 20 kHz
Single Channel Loaded
28 Watts
@
8 ohms
@
10% THO
@
40 - 150 Hz
Single Channel Loaded
*Power rating conforms to FTC Amplifier Rule #16 C.F.R. Part 432.
6
Advertisement
