Advertisement
MANUAL ADDENDUM
After selecting the operating system file you wish to load, press the LOAD O/S soft key (F5/F6).
You will receive the prompt:
The EXECUTE key's LED will flash and you should respond accordingly. If you press EXIT, the
process will be aborted. If you press EXECUTE, the system will load the selected operating system
into the RE32's Flash ROM. The bottom line of the LCD will keep you informed of progress.
WARNING!
Do not switch off the RE32 while the Flash ROM is being erased or programmed.
If you do, the RE32 may not reboot when next powered up.
When the new operating system has been programmed into Flash ROM, a display similar to the
following will be shown:
The bottom line of the screen shows a hexadecimal checksum of the Flash ROM's contents (0A18
in the example above) which should match the checksum distributed with the operating system
file. Once the software has been correctly loaded, it is necessary turn the RE32 off and then
power it back on. It will re-boot with the new version of software you just loaded.
3
Version 1.01-Addendum
Advertisement
