1.0 Preparation/installation We recommend using the adhesive plate (E) since it is On the left side of the helmet, locate the most suitable Put on the helmet once again and check whether the ear- more aerodynamic and can be placed wherever you like point for inserting the clip, slide the rear section of the phones are correctly positioned .
The pairing procedure can be repeated at any time and The device will detect the F5 (with the name Interphone F5) justed independently . must be performed at least once, even with other F5 units and will be paired automatically .
play the number/name of the caller or offer other phone- Built-in FM radio The steadily lit blue LED shows that intercom communi- If you exit the intercom mode during conference three- related functions . To activate the radio function on the F5, press the UP but- cation is enabled .
ers are connected, a slight delay in communication will oc- 3.4 operating precautions Instructions issued in April 2011 . cur which varies with the number of users, and audio quality Do not open, replace, or remove the internal battery pack . www.interphone.cellularline.com Regularly log on to will be lower .
Page 10
0560 It - Per una tenuta stagna ottimale, applicare un sottile strato di silicone sulla parte evidenziata nell’immagine Made in Philippines sottostante . Model: BTMOTOF5 FCC ID: QVNBTMOTOF5 En - For optimum water proofing, apply a thin coat of Silicone Grease on the highlighted portion shown in the picture IC: 7717A-BTMOTOF5 below .
Need help?
Do you have a question about the interphone F5 and is the answer not in the manual?
Questions and answers