Auto Clock Setting - Sharp Aquos LC-20B4U Operation Manual

SETTING THE CLOCK (Continued)
5
Press .....
/~
to select AUTO or
AUTO CLOCK
MANUAL. eRETURN
In' EDS CH SET [AUTO
EDS CH [---]
START
6
Press
./T
to move the cursor to
START, and press ENTER.
ADJUST:@
ENTER:. EXIT: •
PLEASE WAIT
NOW SEARCH ING TIME
•
If you do not know the channel that
carries EDS signals in your area,
select EDS CH SET to AUTO and
select START. If you know the
STOP:@
channel of the EDS signal carrier in
your area, select EDS CH SET to
MANUAL. Set the EDS CH and
2
select START.
•
When set to "AUTO CLOCK", the
time is acquired automatically when
MAIN POWER is turned OFF. (This
function will not work when EDS
CH is not set.)
In'STEREO <ON AIR
SAP
MONO 11:53AM
I
NOTE
>
• CLOCK: The AUTO CLOCK Setting may take from several minutes to an hour depending on the number of
channels to receive and signal status.
• If there are no channels with EDS signals or the antenna signal is weak, the AUTO CLOCK Setting may not
operate. In this case, an "EDS CH IS NOT AVAILABLE" message will display, and the MANUAL CLOCK Setting
screen appears. Refer to MANUAL CLOCK Setting on page 19 to set the clock manually.
• If you know the Channel of the EDS signal carrier in your area, set EDS CH SET to MANUAL and select START.
In case, the message "EDS CH (XXX) EDS DATA IS NOT AVAILABLE" displays, set EDS CH SET to AUTO when
the AUTO CLOCK Setting screen appears.
• If broadcasting channels are not memorized, EDS signals cannot be received even when the EDS CH SET is set
to AUTO. In this case, try EZ SETUP again. (See page 33.)