Peavey Escort 6000 Operating Manual page 29

Problem
No sound
(LCD not lit)
No sound
(LCD lit)
No Effects
Files on USB memory device will not
play back
Loud howling or squeal
from speakers
Sound is distorted
No sound
(Bluetooth )
®
Escort 6000 Specifications:
®
Output Power:
Frequency Response:
Overload Protection:
Distortion:
Signal/Noise Ratio:
AC Power:
Weight Assembled:
(stands included)
Dimensions:
Speakers:
Escort 6000 Troubleshooting Guide
®
Check
Is power switch on?
Is line cord connected to live power outlet?
Are MASTER and CHANNEL GAIN controls up?
Are the channel EFX controls turned up?
Is the master EFX MUTE enabled?
Is an effect activated in menu?
Is the file cued for playback?
Are the audio files the proper format?
If it goes away when the CHANNEL or MASTER LEVEL
controls are turned down, then it is acoustic feedback.
Is the CHANNEL GAIN at a very high setting?
Is the "Active" light flashing?
300 watts RMS (per channel)
40 Hz to 20 kHz +/-3 dB
10 dB of DDT that limits the PA output to prevent clipping that can damage the speakers
™
Less than 0.2% THD @ Max power
88 dB mic input typical
115 V AC 60 Hz or
230 V AC 50/60 Hz
50 lbs. (22.67 kg)
14.5" H x 36.75" W x 15.5" D
(36.8 cm x 93.3 cm x 39.4 cm)
Woofer 10" (254 mm)
Piezoelectric Horn Tweeter
Correction
Turn power switch on
Connect power cord to live outlet
Adjust both MASTER and CHANNEL LEVEL
controls upward to desired level. Check
speaker connections. Turn mic switch on.
Check mic or sound source connection.
Make sure desired effect is selected in
Master effect menu. Check the master
EFX MUTE. If the LED is illuminated the
EFX MUTE is active. Press the EFX MUTE
button once to disable. Adjust channel
EFX control until audio effect is heard.
Make sure once MEDIA SELECT knob is
rotated to display desired file the knob
is then pressed to cue the file. Make sure
your audio files are the correct format.
See the list of supported audio formats
mentioned previously in this manual.
Reduce microphone gain. Reposition
microphone behind or farther from
speakers. Observe FLS light above
Graphic EQ and reduce level of
corresponding slider.
Reduce LEVEL controls accordingly.
Start with CHANNEL LEVEL then adjust
MASTER LEVEL accordingly to achieve
desired volume with no distortion.
Place the Bluetooth/USB switch in the
"Bluetooth" position.
Bluetooth enabled device must be "paired"
before music can be played through the
Escort 6000. Once the device is paired, the
Active LED will light continuously.