Advertisement
screws securing the fuel basket and put to one side. Pull forward and lift up the
fuel support, detach the effects mechanism by sliding the rod off the motor shaft.
Remove the faulty bulb by screwing the bulb anti -clockwise,
Fit the new bulb and reconnect the
effects mechanism.
Relocate the fuel support
and secure using the two screws.
Replace the loose coals.
Automatic Cut Out
A cut out is fitted to the heating element to prevent damage due to over heating.
If it operates due to an obstruction in the airflow, the heater must be turned off
and allowed to cool for 15 minutes and the obstruction removed before
restarting.
Care and Cleaning
The heater and glass parts need only to be wiped clean with a dry soft cloth, do
not use polishes or abrasive materials.
Fault Finding
If the stove functions manually but not by the remote control handset replace the
handset batteries (2 x AAA Alkaline)
No light from the fuel effect: possibly a bulb failure. Remove the faulty bulb as
detailed above and check it in a table lamp that is known to work.
No heat or light: check the wall socket by plugging in a known working
appliance. If functional, check the 13A fuse in the heater plug. If either fuse or
socket is suspected, have them checked by an electrician.
Light but no heat: Check that the Thermostat on the stove is set above
ambient room temperature, alternatively the automatic cut out, may have
operated, see Automatic Cut Out section.
Disposal
The plug should be removed from the mains cable and the mains cable cut from
the heater.
Environmental Protection.
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your local
authority or retailer for recycling advice.
screws
I I I I I I I I
Fuel support removal
Effects mechanism
Slide off
Bulbs
Turn
Turn anti
clockwise
clockwise
to remove
to tighten
6
Advertisement
