Advertisement
Siting
The heater is designed to be free standing on a hard level surface. When siting
please bear the following points in mind
•
•
If you are placing the heater in an alcove, make sure that 150mm-side
clearance is maintained to ensure good air circulation
•
• The heater must not be located under a fixed electrical socket, the
socket must always be accessible in order to disconnect the heater
from the electrical supply for maintenance or when replacing a lamp.
• Keep hearth rugs and other soft furnishings etc. away from the front of
the heater. They could obstruct the free flow of hot air from the fan
and damage both soft furnishings and heater.
150mm
Installation
Before connecting the heater to the power supply for the first time, it is
necessary to arrange the loose coal on the fuel support inside the heater.
Open the heater door and arrange the coal on the support to achieve the
desired effect.
It is not necessary to use all the supplied coal.
Important! This heater must be earthed
The heater is supplied with a 3 pin 13A fused re–wireable plug with 1mm². 3
core mains cable,
L = Brown
The mains supply cable must be safely routed from the heater to an electrical
socket. If the mains cable is damaged, to avoid a hazard it must be replaced by
an authorised service agent or a similarly qualified person.
All external wiring between the appliance and the electrical supply, including the
earth, shall comply with current IEE regulations
controls
N = Blue
150mm
.
E= Green/Yellow
3
Advertisement
