Table of Contents
Advertisement
Switching On/Off
To Switch the TV On
•
Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up (The led will blink
during the standby On/Off).
•
To switch the TV on from standby mode either:
•
Press the "
" button, CH
button on the remote control.
•
Press the control switch on the left hand side of the
TV. The TV will then switch on.
Note: If you switch on your TV via CH
buttons on the remote control or on the TV set,
the programme that you were watching last will be
reselected.
To Switch the TV Off
•
Press the "
" button on the remote control or hold
the on the TV until shut down, so the TV will switch
to standby mode.
•
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, the
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active
First Time Installation
IMPORTANT: Ensure that the aerial is connected
and a Common Interface module is not inserted
before switching on the TV for the first time
installation.
•
When the TV is operated for the first time, the
installation wizard will guide you through the
process. First, the language selection screen will
be displayed:
•
Use "
" or " " buttons to select your language
and press OK button to set the selected language
and continue.
•
After selecting the language, "
be displayed, requiring you to set Country,Teletext
Language and Scan Encrypted options.
or CH
or a numeric
or CH
Welcome!" screen will
English - 9 -
•
By pressing "
" or " " button, select the country
you want to set and press " " button to highlight
Teletext Language option. Use " " or " " button
to select desired Teletext Language.
•
Press "
" button after setting Teletext Language
option. Scan Encrypted will be then highlighted.
You should set the Scan Encrypted as Yes if you
want to scan coded stations.Afterwards select the
desired Teletext Language.
•
Press
OK button on the remote control to continue
and the following message will be displayed on the
screen:
To select the "Yes" or "No" option, highlight the item by
using " " or " " buttons and press OK button.
Afterwards the following OSD will be displayed on
the screen and the TV will search for both digital and
analogue TV broadcasts.
•
Note: You can press
End of the search process, "Choose Region" osd will
be displayed on the screen (if any multiple region
variants are detected).Please select country and
region choice then press OK to continue.
"MENU" button to cancel.
Hide quick links:
Advertisement
Chapters
Table of Contents
