Information - Panasonic CS-E7LKR Operating Instructions Manual

Table of Contents

Advertisement

POWER SUPPLY
Do not use modifi ed cord, joint
cord, extension cord or unspecifi ed
cord to prevent overheating and
fi re.
Do not share the same power outlet with other
equipment to prevent overheating and fi re.
Do not operate with wet hands to prevent electric shock.
If the supply cord is damage, it must be replaced by
the manufacturer, its service agent or similarly qualifi ed
persons in order to avoid a hazard.
It is strongly recommended to be installed with Earth
Leakage Circuit Breaker (ELCB) or Residual Current
Device (RCD) to prevent electric shock or fi re.
This equipment must be earthed to prevent electrical
shock or fi re.
Prevent electric shock by switching off the power supply
when:
- Before cleaning or servicing.
- Extended non-use.
- Abnormally strong lightning activity.
Stop using the product when any
abnormality/failure occurs and disconnect
the power plug or turn off the power switch
and breaker.
(Risk of smoke/fi re/electric shock)
• The ELCB trips frequently.
• Burning smell is observed.
• Abnormal noise or vibration of the unit is
observed.
Examples of
Examples of
• Water leaks from the indoor unit.
abnormality/
abnormality/
• Power cord or plug becomes abnormally hot.
failure
failure
• Fan speed cannot be controlled.
• The unit stops running immediately even if it
is switched on for operation.
• The fan does not stop even if the operation
is stopped.
Contact immediately your local dealer for
maintenance/repair.

INFORMATION

FOR SEASONAL INSPECTION AFTER EXTENDED NON-USE
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select Cooling/Heating operation, after
15 minutes of operation, it is normal to have the following temperature
difference between air inlet and air outlet vents:
Cooling: ≥ 8°C
FOR EXTENDED NON-USE
• Activate Heat mode for 2~3 hours as an alternative to remove moisture left in
the internal parts thoroughly to prevent mould growth.
• Turn off the power supply.
• Remove the remote control batteries.
WARNING
WARNING
Heating: ≥ 14°C
INDOOR UNIT AND OUTDOOR UNIT
Do not wash the indoor unit with water, benzene, thinner
or scouring powder.
Do not use for other purpose such as preservation of
food.
Do not use any combustible equipment in front of the
airfl ow outlet to avoid propagation fi re.
Do not expose yourself directly to cold air for a long
period.
Do not sit or step on the unit, you may fall
down accidentally.
Do not touch the sharp aluminium fi n, sharp
parts may cause injury.
Do not switch ON the indoor unit when waxing the fl oor.
After waxing, aerate the room properly before operating
the unit.
Do not install the unit in oily and smoky areas.
Ensure drainage pipe is connected properly. Otherwise,
leakage may occur.
Aerate the room regularly.
After long period of use, make sure the installation rack
is not deteriorate to prevent the unit from falling down.
REMOTE CONTROL
Do not use rechargeable (Ni-Cd) batteries.
It may damage the remote control.
Remove the batteries if the unit is not going to be used
for a long period of time.
New batteries of the same type must be inserted
following the polarity stated to prevent malfunction of the
remote control.
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY then please consult
authorized dealer under the following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote
control.
• Water leaks from Indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
CAUTION
CAUTION
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cu-e7lkrCs-e9lkrCu-e9lkrCs-e12lkrCu-e12lkrCs-e15lkr ... Show all

Table of Contents