Thank you for purchasing a MTX Marine product. MTX recommends that you have your wakeboard speakers professionally installed. Please visit MTX.com to locate the nearest authorized MTX dealer. TOOLS REQUIRED: • 10mm socket • Speaker wire • ⁄ " drill bit •...
INSTALLATION: Step 1 – First determine where you would like to place the speaker and at what angle the speaker will be mounted. Place enclosure on bar with desired angle and make a mark in the middle of the wire hole on the bar. This mark will be where the speaker wire will come thru the bar into the enclosure.
Page 5
Screw in the 4 speaker bolts, make sure to tighten the bolts fully. NOTE: If bolts are removed after installation, threadlock must be re-applied. Step 6 – Connect speaker wire to amplifier, place boat in water, crank the THUNDER and enjoy. mtx.com/marine...
Page 7
Product found to be defective during that period will be repaired or replaced by MTX at no charge. This warranty is void if it is determined that unauthorized parties have attempted repairs or alterations of any nature.