Automatic Transmission; Replacing The Battery - Mini Coupe Owner's Manual

Controls
Do not depress the brake or the clutch; other‐
wise, the engine will start.
Starting the engine
The engine can be started or the ignition can
be switched on, refer to page 55, when a re‐
mote control is inside the vehicle. It is not nec‐
essary to insert a remote control into the igni‐
tion lock.
Switching off the engine in cars with

automatic transmission

The engine can only be switched off with the
selector lever in position P, refer to page 62.
To switch off the engine with the selector lever
in position N, the remote control must be in‐
serted in the ignition lock.
Before driving a vehicle with automatic
transmission into a car wash
1. Insert the remote control into the ignition
switch.
2. Depress the brake pedal.
3. Move the selector lever to position N.
4. Switch the engine off.
The vehicle can roll.
Malfunction
The Comfort Access functions can be disturbed
by local radio waves, such as by a mobile
phone in the immediate vicinity of the remote
control or when a mobile phone is being
charged in the vehicle.
If this occurs, open or close the vehicle using
the buttons on the remote control or use the
integrated key in the door lock.
To start the engine afterward, insert the remote
control into the ignition switch.
Warning lamps
The warning lamp in the instrument
cluster lights up when you attempt to
30
Opening and closing
Online Edition for Part no. 01 40 2 911 475 - VI/13
start the engine: the engine cannot be started.
The remote control is not in the vehicle or has a
malfunction. Take the remote control with you
inside the vehicle or have it checked. If neces‐
sary, insert another remote control into the ig‐
nition switch.
The warning lamp in the instrument
cluster lights up while the engine is run‐
ning: the remote control is no longer in‐
side the vehicle.
After switching off the engine, the engine can
only be started again within approx. 10 sec‐
onds if no door has been opened.
The indicator lamp lights up: replace
the remote control battery.

Replacing the battery

The remote control for Comfort Access contains
a battery that will need to be replaced from
time to time.
1. Remove the cover.
2. Insert a new battery with the positive side
facing upwards.
3. Press the cover closed.
Return used battery to a recycling center
or to your service center.