Installing The Microphone - Pioneer AVH-X7550BT Owenrs Manual

Dvd rds av receiver
Hide thumbs Also See for AVH-X7550BT:
Table of Contents

Advertisement

Available languages

Available languages

Installation
1
2
1 Side bracket (small)
2 Flush surface screw (5 mm × 6 mm)
2
Install the unit into the dashboard.
Insert the mounting sleeve into the dashboard.
And then secure the mounting sleeve by using a
screwdriver to bend the metal tabs (90°) into
place.
1
182
53
2
3
4
1 Dashboard
2 Mounting sleeve
3 Side bracket
4 Screw (2 mm × 3 mm)
DIN Rear-mount
1
Determine the appropriate position
where the holes on the bracket and the side
of the unit match.
When installing in a shallow space, use the fol-
lowing screw holes.
1
1
1 Use binding screws (4 mm × 3 mm) only.
2
Tighten two screws on each side.
Use any of binding screws (4 mm × 3 mm),
binding screws (5 mm × 6 mm) or flush surface
screws (5 mm × 6 mm), depending on the
shape of screw holes in the bracket.
1
2
3
1 Screw
2 Dashboard or console
3 Factory radio mounting bracket
Note
In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If
this happens, use the supplied frame to fill the
gap.
Removing the unit
Extend top and bottom of the trim ring outwards
to remove the trim ring. And then loosen the
screws (2 mm × 3 mm) to remove the mounting
sleeve.
Installation
! When reattaching the trim ring, push the
trim ring onto the unit until it clicks. (If the
trim ring is attached upside down, the trim
ring will not fit properly.)
1
2
3
1 Mounting sleeve
2 Screw (2 mm × 3 mm)
3 Trim ring

Installing the microphone

(Function of AVH-X7550BT)
CAUTION
It is extremely dangerous to allow the micro-
phone lead to become wound around the steer-
ing column or shift lever. Be sure to install the
unit in such a way that it will not obstruct driv-
ing.
Note
Install the microphone in a position and orienta-
tion that will enable it to pick up the voice of the
person operating the system.
When installing the microphone
on the sun visor
1
Fit the microphone lead into the groove.
1
2
1 Microphone lead
2 Groove
2
Install the microphone clip on the sun
visor.
With the sun visor up, install the microphone
clip. (Lowering the sun visor reduces the voice
recognition rate.)
Section
24
45
En

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avh-x6550dvd

Table of Contents