Ford Mustang 2015 Owner's Manual page 165

When you remove a blockage, you can
reset the system in two ways:
• While driving, the system detects at
least two objects.
• You cycle the ignition from on to off
and then back on.
If the blockage is still present after the key
cycle and driving in traffic, check again for
a blockage.
Reasons for messages being displayed
The radar Clean the fascia area in
surface is front of the radar or remove
dirty or
obstructed
The radar Drive normally in traffic for
surface is a few minutes to allow the
not dirty or radar to detect passing
obstructed vehicles so it can clear the
Heavy rain- No action required. The
fall or system automatically
snowfall resets to an unblocked
interferes state once the rainfall or
with the snowfall rate decreases or
radar stops. Do not use the Blind
signals Spot Information System or
cross traffic alert in these
System Limitations
The Blind Spot Information and cross
traffic alert systems do have their
limitations; situations such as severe
weather conditions or debris build-up on
the sensor area may limit vehicle detection.
Mustang (), enUSA, First Printing
Driving Aids
the obstruction.
blocked state.
conditions.
The following are other situations that may
limit the Blind Spot Information System:
• Certain maneuvering of vehicles
entering and exiting the blind zone.
• Vehicles passing through the blind zone
at very fast rates.
• When several vehicles forming a
convoy pass through the blind zone.
The following are other situations that may
limit the cross traffic alert system:
• Adjacently parked vehicles or objects
obstructing the sensors.
• Approaching vehicles passing at
speeds greater than 37 mph
(60 km/h).
• Driving in reverse faster than 7 mph
(12 km/h).
• Backing out of an angled parking spot.
False Alerts
Note: If your vehicle has a factory equipped
tow bar and it is towing a trailer, the sensors
will detect the trailer and turn the Blind Spot
Information and cross traffic alert systems
off to avoid false alerts. For non-factory
equipped tow bars, you may want to switch
the Blind Spot Information System off
manually.
There may be certain instances when there
is a false alert by either the Blind Spot
Information or the cross traffic alert system
that illuminates the alert indicator with no
vehicle in the coverage zone. Some
amount of false alerts are normal; they are
temporary and self-correct.
System Errors
If either system senses a problem with the
left or right sensor, the Blind Spot
Information System telltale will illuminate
and a message will appear in the
information display.
162