Table of Contents
Advertisement
BIOS Setup
RTC Power On Controller Choose Enabled (default) or Disabled.
RTC Power On
(Hour Ctrl), (Minute
Ctrl), or (Second Ctrl)
Onboard FDC Controller
Onboard Serial Port 1/
Onboard Serial Port 2
UR1 (UR2) Mode
UR1 (UR2) Duplex Mode
Onboard Parallel Port
Printer Port Mode
Enabled Ð Allows you to setup a period
of time to power on the
system after you turn off the
system from Windows 95.
Deisbled Ð Disable this function.
Allows you to set the RTC Power On
timer in hour (0 ~23), minute (0 ~59), or
seconds (0 ~59).
Enabled Ð Use the on-board floppy
controller (default).
Disabled Ð Turn off the on-board floppy
controller.
Choose serial port 1 & 2Õs I/O address.
Do no set port 1 & 2 to the same value
except for Disabled. Options are as
follows:
COM 1/3F8H
COM 2/2F8H
(default)
Choose Standard (default), IrDA or
ASKIR to meet the specification of your
Infra Red device.
Choose Half or Full to meet the
specification of your Infra Red device.
This option appears only when you
choose everything but Standard in the
UR1 (UR2) Mode function.
Choose the parallel port I/O address:
378H/IRQ7 (default), 3BCH/IRQ7,
278H/IRQ5
Choose ECP + EPP (default), SPP or
EPP, ECP mode. The mode depends on
your external device that connects to this
port.
| COM3/3E8H
| COM4/2E8H
33
Advertisement
Table of Contents
