Connecting A Digital Audio System - Toshiba 42L6200U User Manual

34
Connecting Your TV

Connecting a digital audio system

To control the device(s):
Point the TV remote control toward the front of the TV and press
the button for the desired function. The signal passes from the
remote control through the TV to the device via the IR Blaster
cable. For more information, see
(Sample Illustration) Controlling the device(s) - remote control
NOTE
If you cannot locate the device's infrared sensor:
1 Turn off the device.
2 Starting at the device's lower-left corner, place the end of the
device's remote control (with the infrared emitter) so it touches
the front of the device. Press the POWER button.
(Do not use the TV's remote control for this step.)
3 If the device turns on, the sensor is located where the remote
control touched the device.
4 If the device does not turn on, move the remote control slightly
to the right and press the POWER button again.
5 Repeat the previous steps if necessary.
Connecting a digital audio system
The TV's Digital Audio Out terminal outputs a Dolby
2-channel down-mixed PCM (pulse-code modulation) signal for
The IR pass-through feature does not support all IR controlled
devices. Satisfactory quality may not be attainable with certain
devices.
"IR Blaster Setup" on page 55.
®
Digital or