Blackspot Interactive Road Angel User Manual page 9

Adding an Average Speed monitoring section or
SPECS area
The use of SPECS cameras are becoming more frequent,
both in residential areas and on Motorways. A photograph is
taken of your vehicle at the 'start' point and then another a
set distance further down the road. If your average speed is
greater than the speed limit between these two cameras
you are automatically prosecuted.
You can record these areas as follows. Only store an average
speed monitoring area if you are absolutely sure of the start
and finish points.
When passing underneath the first 'start' SPECS camera
carry out the following:
Press STORE once to store the first camera position.
Press MENU twice to move the location type to AVERAGE.
Press STORE to confirm type – logging appears on
the screen.
Now wait until you are underneath the finish camera
Press STORE to confirm the finish position.
The section of average speed detection is now stored.
Note: Blackspot Interactive Ltd. are constantly updating the central
database of danger zones. You can be of great value to all ROAD
ANGEL users by noting new information accurately and updating to
our central database. All general information will be verified by
Blackspot Interactive Ltd. before adding it to the central file.
Adding & Deleting
Danger Zones
Back To Contents
8